BOSCH BL2191 1 In. x 6 in. Sveder iz črnega oksida z delno zmanjšanim steblom

Name: BOSCH BL2191 1 In. x 6 in. Sveder iz črnega oksida z delno zmanjšanim steblom
Brand: BOSCH
SKU: 0000346332360
Price: 58.71 EUR
Availability: InStock

Brand:BOSCH

3.2/5

€
58.71

Za uporabo v jeklu, bakru, aluminiju, medenini, hrastu, javorju, MDF, boru, PVC-ju, polikarbonatu, akrilu, ABS, najlonu in kompozitnih materialih. Na voljo v dolžini Jobber, dolžini za čokat, podaljšani dolžini (letalo), 1/2 In. zmanjšano steblo (Silver in Deming). Enostavnejše vrtanje, zmanjšana toplota in podaljšana življenjska doba svedra. Traja 50 odstotkov dlje kot hitrorezno jeklo. Zasnova Speed Helix za trikrat hitrejše vrtanje kot standardni svedri.

Znesek

Dodaj v voziček Kupi zdaj

EAN: 0000346332360

kategorije Močno in ročno orodje, Dele in pribor za električno orodje, deli in pribor za električne vrtalnike, Vrtalnike Ostružniki vrtalnih bitov, , Svedri za vrtanje,

Brand	BOSCH
Finish Type	Black Oxide
Material	Brass
Shank Type	Straight
Tool Flute Type	Spiral

5 Star

4 Star

3 Star

2 Star

1 Star

Napišite svojo oceno

Vaš email ne bo objavljen. Vsa obvezna polja so označena z^*

Vaša ocena

Scritto da: Jack

Heavy duty drilling in steel

Yes, does a fantastic job, even in hardened cast-iron. I found that a 350 rpm setting on your heavy duty drill press is perfect.

Scritto da: opinions are like A_ _ holes

sharp

this is a good quality drill bit. it cuts great and seems to stay sharp. i always use cutting oil so im sure that helps as well

Scritto da: Damon

Just as the doctor ordered

Needed a 1" drill bit to drill through Robinson's decking after pilot hole. Works great.

Scritto da: WBS

Not for heavy duty use

I knew it was HSS black oxide and not Cobalt but I only needed to widen 8 holes from 7/8 inch to 1 inch in 1/4 hard steel. Got four done but last one was extremely hard to do. Not sure now whether the bit will handle soft metal.

Scritto da: Paul Vitolins

Cuts like a champ. As one would expect from Bosch

Cuts well and stays sharp! Very satisfied. Thanks!

Scritto da: notme

so far so good

drilled a few holes with it, only thing I don't like is it would be better if the shank had 3 flats.....

Scritto da: Ronny Dwiputra

CAN DRILL 1" THICK OF STEEL

So I used this drill bit with some lubricant to extend the hole of my trailer hitch from 3/4" to 1". It's like drilling 1"-1-1/2" thick of steel. I took me like 20 mins of drilling, but it works, even just with my cheap RYOBI drill.