Eastman 35312 priključek za odcep s prirobnico in priključkom drsnega spoja, 1-1/2 palca x 8 palcev, bela

Brand:Eastman

3.3/5

26.20

Ima drsno povezavo za hitro in enostavno namestitev. Opremljen z 7/8-palčnim odvodom OD z bodico za vgradnjo v pomivalni stroj. Zasnovan za povezavo odtoka napeljave s sifonom v cevnih vodovodnih aplikacijah. Izdelan iz trpežnega polipropilena za zagotavljanje odpornosti proti gospodinjskim kemikalijam. Prirobljeni nastavek veje meri 1-1/2 palca x 8 palcev.

Ima drsno povezavo za hitro in enostavno namestitev. Opremljen z 7/8-palčnim odvodom OD z bodico za vgradnjo v pomivalni stroj. Zasnovan za povezavo odtoka napeljave s sifonom v cevnih vodovodnih aplikacijah. Izdelan iz trpežnega polipropilena za zagotavljanje odpornosti proti gospodinjskim kemikalijam. Prirobljeni nastavek veje meri 1-1/2 palca x 8 palcev.
Brand Eastman
Color White
Connector Type Flange, Trap
Exterior Finish White
Item Dimensions LxWxH 8.4 x 3.3 x 1 inches
Material Polypropylene
Number Of Pieces 1
Size 1-1/2 inch x 8 inch

3.3

3 Review
5 Star
64
4 Star
21
3 Star
0
2 Star
5
1 Star
10

Napišite svojo oceno

Vaš email ne bo objavljen. Vsa obvezna polja so označena z*

Scritto da: sam
Works
The dishwasher port is a tad small but it worked
Scritto da: Lakeviews
Slip joint portion of this product it too shallow (short).
The slip joint ("S/J") section of the tailpiece is too short to provide adequate stability. This product is advertised as working as a direct connect, it can butt up against the sink drain, or as a slip joint, allowing it to partially slip over another section of drain pipe. In my case I only had enough clearances under the sink to mount this item horizontally between the P trap and the stub out from the wall. Mounting it horizontally introduces a bit of torque on the joint where this product slides over the P trap's exit pipe. The slip joint portion of this product is only about 3/4" deep (2mm). To provide sufficient stability it should really be at least an inch deep (allowing the other pipe to slide into it at least an inch. I thoroughly looked at it and the alternatives carried by Amazon and decided to go with this product, even though I suspected the shallowness of the slip joint might be a problem. It is in place and doesn't leak yet, but it's not been subjected to many dishwasher runs. The pulsing of jets of water from the dishwasher during the drain cycle may cause it to fail and start to leak.
Scritto da: C. LuzHoxsie
2nd best option if a garbage disposal is not available.
I had a temporary sink while my counters were getting fabricated and this worked well since I did not have a garbage disposal to hook my dishwasher too.

Podobni izdelki

hot
NIBCO 5817 Cap Hub - ABS DWV, 3
3.5/5

€ 44.54

NIBCO 5817 Cap Hub - ABS DWV, 3
3.5/5

€ 44.54

Odkrijte našo mednarodno mrežo

Pošiljamo v 28 držav, več kot 200.000 izdelkov. Bodite na tekočem, naročite se na glasilo.

Array