Steblo svedra za namestitveno orodje Eagle Tool US ET18721, uporablja se z zamenljivimi glavami preklopnih nastavkov, 3/16-palčni x 21-palčni, izdelano v ZDA 3/16 in. 21 in.

Brand:Eagle Tool US

3.9/5

44.63

Eagle Tool posamezna velikost, fleksibilna stebla iz vzmetnega jekla. Prilagodljiva stebla iz vzmetnega jekla so opremljena z luknjami za namestitev rib, tremi ravnimi, nedrsečimi ročaji vpenjalne glave in brušeno nedrsečo zarezo za zamenljivo glavo. Luknja za lovljenje žice na koncu vpenjalne glave. Steblo meri 3/16-palčni premer in 21-palčno dolžino.

Komplet zamenljivih nastavnih vijakov in imbus ključev ETAKIT2. Luknja za lovljenje žice na koncu vpenjalne glave. Nedrseč ploščat (konec svedra) in nedrseč triploski oprijem (konec vpenjalne glave). Fleksibilno steblo iz vzmetnega jekla. Za uporabo z glavami ETS375, ETS562, ETH375, ETM375 in podaljškom ETHXKIT187.
Brand Eagle Tool US
Country of Origin USA
Cutting Angle String 135 Degrees
Domestic Shipping Item can be shipped within U.S.
Finish Type Black Oxide
International Shipping This item can be shipped to select countries outside of the U.S.
Item model number ET18721
Manufacturer Eagle Tool US
Material Alloy Steel
Shank Type Round

3.9

2 Review
5 Star
89
4 Star
11
3 Star
0
2 Star
0
1 Star
0

Napišite svojo oceno

Vaš email ne bo objavljen. Vsa obvezna polja so označena z*

Scritto da: Amazon Customer
Much better than single piece design
I have a business that provides low-voltage installation services. I greatly prefer an interchangeable setup like this over single piece (bit plus shaft design). With the single piece once you dull the bit you have to replace the entire thing (at $30-50 a pop), not to mention you end up needing 4-8 different bits to accommodate different drill bit sizes and lengths. It is easy to attach a new bit and the lip design helps prevent the bit from spinning loosely. The reason for 4 stars is because you have to really make sure to get the screws tight on this otherwise you end up with a bit stuck inside the wall. FYI the 90 degrees is for the entire length of the rod, dont expect to make a 1" hole and bend this at a sharp 90 degree angle. Also the larger the drill bit the slower you should go with your drill. If you try to push a 3/4" bit through a double 2x4 header at max speed you will likely break the rod before you drill through.
Scritto da: Jarrod Major
A decent size for those hard-to-reach places
Pretty simple tool, not much to say, it does the job. 1/4" shank is very rigid. Like the convenient hole on the drill side for wire pulls.

Podobni izdelki

hot

Odkrijte našo mednarodno mrežo

Pošiljamo v 28 držav, več kot 200.000 izdelkov. Bodite na tekočem, naročite se na glasilo.

Array